Lathe User Manual



Offsetting Tailstock
       
        
       
       
       
      


Note: To return the tailstock to the center position,
perform the Tailstock Alignment procedure on
the next page.
Tools Needed Qty
 
To set up the tailstock to cut a shallow taper:
1. 

       
Figure 38
5.       

       

6.        

       

7.      
      
        

 Note: Do not overly force the center into
the workpiece with the handwheel—this will
make removing the center very difficult and
could damage it.
8.        




Figure 38.



