Lathe User Manual



Tensioning/
Replacing V-Belts
NOTICE
After the first 16 hours of use, the V-belts
will stretch and seat into the pulley grooves.
The V-belts must be properly re-tensioned
after this period to avoid severely reducing
their useful life.

       



       

Tools Needed Qty
 
 
 
Tensioning V-Belts
1. 
2. 

3. Figure 81 


4. 
  
    Figure 82 




3
⁄4" Deflection
Adjustment
Hex Nuts & Bolts
Figure 82.




      

      
      

5.        

        


Figure 81.


