Lathe User Manual



Shear Pin
Replacement


        
Figure 90       
       
   


Tools Needed Qty
 
 
 
To replace the shear pin:
1. 
2.        
       
      

3. 
Figure 91
 Note: Take care not to put pressure on the
leadscrew or rods when the end bracket is
removed to prevent bending them.
Figure 91.


4. 
     

5. 
     
      
        

 Note: Keep in mind that the shear pin hole
is tapered and must be properly aligned to
accept a new tapered shear pin.
6. 
7. 
Figure 90.

