Lathe User Manual

"')"
BdYZa<%+.-B[\#h^cXZ&%$%.
Installing Headstock
Faceplate
3. Jh^c\i]Z^cXajYZY)bb]ZmlgZcX]!i^\]iZc
i]ZildhZihXgZlhVadc\i]Z^ch^YZY^VbZiZg
d[ i]Z [VXZeaViZ id hZXjgZ ^i id i]Z he^cYaZ
hZZFigure 27#
To prevent the faceplate and workpiece
separating from the spindle during opera-
tion, the headstock faceplate MUST be firmly
threaded onto the spindle and secured in
place by fully tightening the two faceplate
set screws. If these instructions are not
properly performed, serious personal injury
could occur.
Note: To remove the headstock faceplate, discon-
nect the lathe from the power source and perform
the steps above in reverse.
=ZVYhidX`;VXZeaViZ
Figure 27.=ZVYhidX`[VXZeaViZhZihXgZl#
To install the headstock faceplate:
1. 9>H8DCC:8IA6I=:;GDBEDL:G
2. I]gZVYi]Z[VXZeaViZdcidi]Zhe^cYaZjci^a^i
^hhcj\#>[cZXZhhVgn!^chZgii]Z^cYZm^c\e^c
^ciddcZd[i]Z^cYZm^c\]daZhVcYgdiViZi]Z
he^cYaZ jci^a i]Z e^c Zc\V\Zh id egZkZci i]Z
he^cYaZ [gdb ijgc^c\ l]^aZ ndj i^\]iZc i]Z
[VXZeaViZFigure 26#
Figure 26.AdX`^c\he^cYaZl^i]^cYZm^c\e^c#
;VXZeaViZHZiHXgZl&d['