Lathe User Manual

"'+"
BdYZa<%,((B[\#H^cXZ&%$&&
Always choose the correct spindle speed
for an operation. Using the wrong speed
may lead to the workpiece being thrown at
high speed, causing fatal or severe impact
injuries.
2. DeZci]Z[gdciWZaiVXXZhheVcZa!Vhh]dlc^c
Figure 29#
3. AddhZc i]Z WZai iZch^dc adX` ]VcYaZ
Figure 30#
Figure 29.7ZaiVXXZhheVcZagZbdkZY#
4. JhZi]ZWZaiiZch^dc^c\]VcYaZFigure 30id
a^[i i]Z bdidg VhhZbWan Vaa i]Z lVn je! i]Zc
gZ"i^\]iZc i]Z WZai iZch^dc adX` ]VcYaZ·i]^h
l^aa]daYi]Zbdidg^ceaVXZl]^aZndjX]Vc\Z
i]ZWZaiedh^i^dc#
Figure 30.BdidgiZch^dc^c\]VcYaZVcYiZch^dc
adX`]VcYaZ#
7ZaiIZch^dc^c\
=VcYaZ
7ZaiIZch^dc
AdX`=VcYaZ
5. GZVX]^cidi]ZWZaiVXXZhhXVk^inVcYgdaai]Z
WZaidcidi]ZYZh^gZYhZid[ejaaZnh!Vhh]dlc
^cFigure 31#
6. AddhZc i]Z WZai iZch^dc adX` ]VcYaZ VcY
adlZgi]Zbdidg#
7. 6eeanYdlclVgYegZhhjgZdci]ZWZaiiZch^dc"
^c\]VcYaZidegdeZganiZch^dci]ZYg^kZWZai!
i]ZcgZ"i^\]iZci]ZWZaiiZch^dcadX`]VcYaZ#
 Note: When properly tensioned, the belt
should deflect about
1
⁄8" when moderate pres-
sure is applied to the belt mid-way between
the upper and lower pulley, as shown in
Figure 32.
8. GZeaVXZi]Z[gdciWZaiVXXZhheVcZa#
Figure 32.IZhi^c\[dg
&
¿-WZaiYZ[aZXi^dc#
EjaaZn
9Z[aZXi^dc
EjaaZn
Figure 31.HeZZYgVc\ZWZaiedh^i^dch#
He^cYaZ
Bdidg
7
6
6 2=^\]GVc\Z
((%"('%%GEB
7
2AdlGVc\Z
&%%"&'%%GEB