Planer User Manual



Rotating/Changing
Carbide Cutters
Tools Needed: Qty
 



      
Figure
26
        


        


Figure 26. 
To rotate or change a carbide cutter:
1.     

2.        

3. 
4.      

       

 Note:Proper cleaning is critical to achieving
a smooth finish. Dirt or dust trapped between
the cutter and cutterhead will slightly raise the
cutter, and make noticeable marks on your
workpieces the next time you plane.
5.       
    


 Note: Excess oil may squeeze between the
cutter and cutterhead, thereby lifting the cut-
ter slightly and affecting workpiece finishes.
