- GRIZZLY 6" X 47" HEAVY-DUTY JOINTER INSTRUCTION MANUAL G1182HW, G1182ZHW, G1182Z, G1182ZX

-12- G1182 6" Series Jointers
3. Position the dust chute base between the dust
chute sides (flanges up), carefully aligning the
screw holes in the base and the sides. See
Figure 4 and 5. The flanges should be inside
the chute.
Figure 5. Attaching the dust chute base.
4. Attach the top of the stand to the sides and
dust chute. Note that the flanges for the top
are inside the stand (the flanges for the dust
chute opening should be outside the dust
chute, however) and that the opening for the
drive belt is at the rear of the stand. See
Figure 6.
5. Turn the stand upside down to mount the
motor to the underside of the dust chute.
Mount the motor on the chute using the four
5
⁄16" - 18 x
3
⁄4" hex head bolts, flat washers and
nuts provided. Be sure to position the motor
pulley to the rear (open end) of the stand as
shown in Figure 7. Leave the motor mount
bolts finger-tight for now.
Figure 6. Attaching the top of the stand.
Figure 7. Attaching the motor.
NOTICE
Make sure the slots in the motor support are
toward the top of the stand.
Figure 4. Attaching the dust chute.