MODEL H0778/H0779 ELECTRIC HOIST OWNER'S MANUAL Copyright © JULY, 2008 By Grizzly Industrial, Inc. Warning: No portion of this manual may be reproduced in any shape or form without the written approval of Grizzly Industrial, inc.
SECTION 1: SAFETY 4HIS MANUAL PROVIDES CRITICAL SAFETY INSTRUCTIONS ON THE PROPER SETUP OPERATION MAINTENANCE AND SERVICE OF THIS MACHINE EQUIPMENT &AILURE TO READ UNDERSTAND AND FOLLOW THE INSTRUCTIONS GIVEN IN THIS MANUAL MAY RESULT IN SERIOUS PERSONAL INJURY INCLUDING AMPUTATION ELECTROCUTION OR DEATH 4HE OWNER OF THIS MACHINE EQUIPMENT IS SOLELY RESPONSIBLE FOR ITS SAFE USE 4HIS RESPONSIBILITY INCLUDES BUT IS NOT LIMITED TO PROPER INSTALLATION IN A SAFE ENVIRONMENT PERSONNEL TRAINING AND USAGE AUTHO
Safety Instructions for Electric Hoists 1. READ THROUGH THE ENTIRE MANUAL BEFORE USING. This electric hoist represents serious injury hazards to untrained users. 2. NEVER ALLOW UNQUALIFIED PERSONNEL TO SERVICE THIS HOIST. Servicing the hoist incorrectly may reduce the maximum holding capacity. 3. DO NOT LIFT MORE THAN THE MAXIMUM SUGGESTED CAPACITY. Be aware that the load weight, harnesses, and load bearing equipment all contribute to the total load weight. Overloading may cause the load to fall. 4.
SECTION 2: INTRODUCTION Foreword Contact Info It is our pleasure to provide this manual with the Model H0778/H0779. It was written to encourage safety considerations and guide you through general operating procedures and maintenance. If you have any comments regarding this manual, please contact us: The specifications, details, and photographs in this manual represent the Model H0778/H0779 as supplied when the manual was prepared.
SECTION 3: SET UP Unpacking A Your electric hoist was carefully packaged for safe shipping. If you discover any damage after you have signed for delivery, immediately call Customer Service at (570) 546-9663 for advice. B D C Save the containers and all packing materials for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult. When you are completely satisfied with the condition of the shipment, you should inventory the contents.
Setup The Model H0778/H0779 electric hoist comes pre-assembled. The hoist only needs to be mounted. There are many mounting options for your hoist. It may be mounted on a stationary pipe or on a rotating pillar (Figure 3). Figure 4. Mounting the hoist (pole not shown for clarity). 3. Firmly tighten the hex bolts and check to make sure the hoist does not swing or move on the pipe. Mounting and Loading Hardware When attaching hardware to the electric hoist: Figure 3. Hoist mounted on a rotating pillar.
Test Run 3. Let go of the hook and move to a safe distance. The Model H0778/H0779 electric hoist has a safety stop microswitch that will automatically shut OFF the motor before the lift or pulley hook can be retracted into the housing. If the hook is allowed to retract into the housing, the hoist will continue to pull the cable until the cable or cable hardware breaks, causing the load to drop and resulting in possible property damage/ injury.
SECTION 4: OPERATIONS To use the electric hoist: 1. Plug the electric hoist into a grounded 110V outlet. 2. Grab the lift hook and pull it away from the hoist while using the control switch to lower the hoist cable by pressing the switch in the down position (Figure 6). Never fully unwind the cable from the electric hoist. Always leave at least 3 turns of cable on the hoist spool to prevent the cable from detaching. 3. Verify the weight of the item to be hoisted.
SECTION 5: MAINTENANCE General Lubrication Check mounting hardware daily before use for cracks, unsafe wear, deformation, or warping. DO NOT attempt to fix the mounting hardware! Discard and replace all damaged mounting hardware. Check daily for loose pins, rings, screws, wires and safety latches. Tighten or replace any loose items. Check daily for damage or fraying along the length of the cable. Damaged or loose parts may cause the load to fall and may result in serious injury.
-8- 7 8 10 9 19 11 20 6 5 3 22 21 14 43 70 13 71 24 1 18 23 16 17 12 12 15 4 2 69 28 68 26 27 24 30 25 63 54 28 53 53 52 72 53 56 36 37 81 51 60 38 73 64 62 65 60 84 66 83 67 82 29 31 34 35 32 33 25A 74 54 39 40 58 76 75 57 55 60 41 35 77 59 42 24 52 61 50 49 27 53 64 48 78 63 53 64 79 45 80 43 44 63 44 54 47 46 43 52 H0778 Breakdown Model H0778/H0779 Electric Hoist
H0778 Parts List REF PART # DESCRIPTION REF PART # DESCRIPTION 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 25A 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 BODY CAP SCREW M8-1.25 X 20 MOUNTING BRACKET HEX BOLT M8-1.25 X 25 G-8.8 EXT TOOTH WASHER 8MM FLAT WASHER 8MM SPOOL END SPOOL WASHER SPOOL FLANGE CABLE CABLE STOP CABLE FASTENING SLEEVE CABLE LOOP GUIDE LIFT HOOK HOIST SPOOL KEY 5 X 5 X 10 EXT RETAINING RING 15MM BALL BEARING 6202ZZ SPACING RACK CAP SCREW M8-1.
+' +( -10- , -) &, &% - +* . +) ++ &- && &+ +& &. &' '% + &( '( ') ++ * '+ ' '- (& '& '. ** (' &. ')6 (% ', &- &) &* '* ) ( & *. '' ,. ,- )' *- (( (* ** *. +% ', () ,+ ,& -( *, (- (( )% ,, ,* *( *& ,' ,% *& ). *% ** *( *' *) +. *+ (+ (, (.
H0779 Parts List REF PART # DESCRIPTION REF PART # DESCRIPTION 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 24A 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 BODY CAP SCREW M10-1.5 X 25 MOUNTING BRACKET HEX BOLT M10-1.5 X 30 EXT TOOTH WASHER 10MM SPECIAL NUT SPOOL END WEDGE SPOOL FLANGE CABLE STOP UPPER CABLE SLEEVE CABLE LOWER CABLE SLEEVE CABLE LOOP GUIDE LIFT HOOK HOIST SPOOL SPOOL WASHER KEY 5 X 5 X 12 EXT RETAINING RING 17MM BALL BEARING 6203ZZ CAP SCREW M8-1.
WARRANTY Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of maintenance.
WARRANTY CARD Name__________________________________________________________________ Street__________________________________________________________________ City_ _______________________ State__________________________ Zip_ _________ Phone #_____________________ Email_ ________________________ Invoice #______ Model #_____________________ Order #________________________ Serial #_______ The following information is given on a voluntary basis.
Send a Grizzly Catalog to a friend: Name________________________________ Street________________________________ City______________State______Zip_______ FOLD ALONG DOTTED LINE Place Stamp Here grizzly INDUSTRIAL, inc. p.o.