JUMP STARTER/COMPRESSOR MODEL H6310 INSTRUCTION MANUAL COPYRIGHT © SEPTEMBER, 2004 BY GRIZZLY INDUSTRIAL, INC. WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
Hazard Lights Red Terminal Clamp Black Terminal Clamp Voltage Meter Flashlight Main Power Switch Flashlight Switch Voltage Meter Switch Hazard Light Switch DC Output Sockets Charging Socket Securing Strap Storage Compartment Air Pump Switch 12V DC Cord Charging Adapter Model H6310 Jump Starter/Compressor 12V DC Output Socket Air Pressure Gauge Air Hose -1-
SAFETY For Your Own Safety Read Instruction Manual Before Operating This Equipment The purpose of safety symbols is to attract your attention to possible hazardous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progression of symbols is described below. Remember that safety messages by themselves do not eliminate danger and are not a substitute for proper accident prevention measures.
6. ONLY ALLOW TRAINED AND PROPERLY SUPERVISED PERSONNEL TO OPERATE MACHINERY. Make sure operation instructions are safe and clearly understood. 7. KEEP CHILDREN AND VISITORS AWAY. Keep all children and visitors a safe distance from the work area. 8. 9. 13. ALWAYS DISCONNECT FROM POWER SOURCE BEFORE SERVICING MACHINERY. Make sure switch is in OFF position before reconnecting. 14. MAKE WORKSHOP CHILD PROOF. Use padlocks, master switches, and remove start switch keys. MAINTAIN MACHINERY WITH CARE.
Additional Safety Instructions for the Jump Starter/Compressor 1. READ THIS MANUAL: This manual contains proper operating instructions for this jump starter/compressor. 2. AVOID SHORTING TERMINAL CLAMPS: Touching red and black terminal clamps together will cause a short and may cause an explosion or fire. Never touch red and black terminal clamps together! 3. 4.
INTRODUCTION Foreword Contact Info We are proud to offer the Grizzly Model H6310 Jump Starter/Compressor. This model is part of a growing Grizzly family of fine power tools. When used according to the guidelines set forth in this manual, you can expect years of trouble-free, enjoyable operation and proof of Grizzly’s commitment to customer satisfaction.
SET UP Unpacking Charging Your jump starter/compressor left our warehouse in a carefully packed crate or box. If you discover damage after you have signed for delivery, please immediately call Customer Service at (570) 546-9663 for advice. The Model H6310 is shipped with a charging adapter that fits neatly into the storage compartment. Save the containers and all packing materials for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult.
OPERATIONS Jump Starter Tire Inflater When jump starting any automobile, always check the actual symbols on the battery to ensure which terminals are positive "+" or negative "-". (DO NOT rely on red or black colors of the cables already connected to the battery, as these are not always consistent.) Also, never touch the red and black terminal clamps together as this will short out the jump starter and may cause fire, explosion, or damage to equipment.
Hazard Lights Securing Strap In the event of an emergency, the hazard lights help notify oncoming vehicles of your presence. This is especially important at night when you are working on the side of a road with busy traffic. The securing strap is included to hang the Model H6310 from the hood of a car. Hanging the Model H6310 will keep it out of the way of moving parts like drive belts and fans. To use the hazard lights: To use the securing strap: 1. Turn the main power switch ON. 1.
TROUBLESHOOTING Symptom Possible Cause Car will not jump start. 1. Bad connection at car battery 1. Clean battery posts, or rotate posts. terminal clamps on post with firm pressure to establish contact. 2. Car battery has lost too much 2. Recharge car battery. charge. 3. Car battery is dead. 3. Replace car battery. Flashlight does 1. Bulb burned out or damaged. not work when 2. Switch is damaged. unit is charged. Unit will charge. not Possible Solution 1. Replace the bulb. 2. Replace switch. 1.
-10- � � � � � � � �� � � �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� Parts Breakdown Model H6310 Jump Starter/Compressor
REF 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 DESCRIPTION PART # PH6310001 PW07M PN07M PH6310004 PH6310005 PH6310006 PH6310007 PH6310008 PHTEK21M PH6310010 PH6310011 PH6310012 PH6310013 PH6310014 PHTEK21M PH6310016 PHTEK22M PH6310018 PLW01M PN06M PH6310021 PH6310022 PH6310023 PHTEK23M PH6310025 PH6310026 PH6310027 PH6310028 PHTEK23M PH6310030 PH6310031 PH6310032 PH6310033 PHTEK2M PH6310035 PH6310036 PH
WARRANTY AND RETURNS Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of maintenance.
WARRANTY CARD Name _________________________________________________________________________ Street ________________________________________________________________________ City____________________State________Zip_________ Phone Number____________E-Mail___________________FAX ____________ Model # H6310 Jump Starter/Compressor Serial#________________Order #____________ The following information is given on a voluntary basis.
Send a Grizzly Catalog to a friend: Name________________________________ Street________________________________ City______________State______Zip_______ FOLD ALONG DOTTED LINE Place Stamp Here GRIZZLY INDUSTRIAL, INC. P.O.