Instruction Manual AIR SANDER H8215

ManualsBrandsGrizzly ManualsSanderH8215

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#JM9838 PRINTED IN CHINA

MODEL H8215

6" DUAL ACTION AIR SANDER

INSTRUCTION MANUAL

Summary of content (8 pages)

PAGE 1
MODEL H8215 6" DUAL ACTION AIR SANDER INSTRUCTION MANUAL COPYRIGHT © AUGUST, 2007 BY GRIZZLY INDUSTRIAL, INC. WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
PAGE 2
��
PAGE 3
SAFETY For Your Own Safety Read Instruction Manual Before Operating This Equipment The purpose of safety symbols is to attract your attention to possible hazardous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progression of symbols is described below. Remember that safety messages by themselves do not eliminate danger and are not a substitute for proper accident prevention measures.
PAGE 4
7. AVOID ENTANGLEMENTS. Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry, which may get caught in moving parts, when operating this tool. Wear a protective hair covering to contain long hair. 8. USE CORRECT AIR PRESSURE. Exceeding the maximum PSI rating of this tool may cause unpredictable operation or bursting. 9. DISCONNECT AIR PRESSURE before servicing, changing accessories, or moving to another location. Never leave this tool unattended when connected to air. 10.
PAGE 5
INTRODUCTION Foreword Specifications The specifications, details, and photographs in this manual represent the Model H8215 as supplied when the manual was prepared. However, owing to Grizzly’s policy of continuous improvement, changes may be made at any time with no obligation on the part of Grizzly. Sanding Pad............................................6" No Load Speed.......................10,000 RPM Air Consumption...............................4 CFM Air Inlet.........................................
PAGE 6
OPERATIONS To set up the Model H8215 Air Sander: 1. DISCONNECT THE SANDER FROM THE AIR SUPPLY! 2. Firmly holding the orbital shaft, rotate the spindle swivel lock against one of the spindle flats. Read the manual before operation. Become familiar with this tool, its safety instructions, and its operation before beginning any work. Serious personal injury may result if safety or operational information is not understood or followed. Like all tools there is potential danger when operating this tool.
PAGE 7
EYE INJURY HAZARD! Wear protective equipment when using this tool. LUNG/EAR INJURY HAZARD! Wear protective equipment when using this tool. ACCIDENTAL START HAZARD! Disconnect before service or tool changes. Operation 1. Connect the tool to compressed air regulated at 90 PSI. AIR PRESSURE HAZARD! Never exceed 120 PSI. 2. Hold the sander firmly and press the throttle lever (Figure 3) to turn it ON. Throttle Lever Daily Maintenance Regulator Knob Figure 3. Sander controls.
PAGE 8
H8215 PARTS LIST � � � � � �� REF PART # DESCRIPTION REF PART # DESCRIPTION 1 2 2-1 3 4 4-1 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 CAP SCREW M6-1 X 35 LOCK WASHER 6MM FLAT WASHER 6MM WAVY WASHER 6MM SPECIAL NUT BRASS BUSHING LOCK NUT M6-1 6" SANDING PAD INT RETAINING RING 32MM WAVY WASHER 12MM DRIVE SPINDLE BA