MODEL H8219 AIR ORBITAL SANDER INSTRUCTION MANUAL COPYRIGHT © AUGUST, 2007 BY GRIZZLY INDUSTRIAL, INC. WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
����������������������������������������������������������������������� �������������������������������������������������������������� ���������������������������������������������������������������������� �������������������������������������������������������������������� ������������������������ ������������������������������������������������������������������ �������������������������������������������������������������������� ����������������������������������������������������������������� ����������
SAFETY For Your Own Safety Read Instruction Manual Before Operating This Equipment The purpose of safety symbols is to attract your attention to possible hazardous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progression of symbols is described below. Remember that safety messages by themselves do not eliminate danger and are not a substitute for proper accident prevention measures.
7. AVOID ENTANGLEMENTS. Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry, which may get caught in moving parts, when operating this tool. Wear a protective hair covering to contain long hair. 8. USE CORRECT AIR PRESSURE. Exceeding the maximum PSI rating of this tool may cause unpredictable operation or bursting. 9. DISCONNECT AIR PRESSURE before servicing, changing accessories, or moving to another location. Never leave this tool unattended when connected to air. 10.
INTRODUCTION Foreword Specifications The specifications, details, and photographs in this manual represent the Model H8219 as supplied when the manual was prepared. However, owing to Grizzly’s policy of continuous improvement, changes may be made at any time with no obligation on the part of Grizzly. No Load Speed.........................8,000 RPM Air Consumption...............................6 CFM Air Inlet.....................................................1⁄4" Required PSI............................
OPERATIONS Attaching Sandpaper 1. DISCONNECT THE SANDER FROM THE AIR SUPPLY! 2. Install the 1⁄4" NPT male quick-connect fitting into the air inlet. Read the manual before operation. Become familiar with this tool, its safety instructions, and its operation before beginning any work. Serious personal injury may result if safety or operational information is not understood or followed. Like all tools there is potential danger when operating this tool.
EYE INJURY HAZARD! Wear protective equipment when using this tool. LUNG/EAR INJURY HAZARD! Wear protective equipment when using this tool. ACCIDENTAL START HAZARD! Disconnect before service or tool changes. Using the Sander 1. Plug the tool into compressed air regulated at 90 PSI. AIR PRESSURE HAZARD! Never exceed max PSI rating for tool. 2. Hold the sander firmly and press the throttle lever (Figure 3) to turn it ON. 3. Turn the regulator knob (Figure 3) to adjust the speed of the air sander.
H8219 PARTS LIST �� �� � � �� �� �� �� �� � � � � � �� �� �� �� �� �� �� �� �� �� �� � �� � �� �� �� �� � �� �� �� �� �� �� �� �� �� �� �� �� �� �� REF PART # DESCRIPTION REF PART # DESCRIPTION 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 MOTOR HOUSING FOAM MUFFLER LEVER PIN COMPRESSION SPRING PLUNGER AIR COUPLER E-CLIP 5MM O-RING 4.8 X 1.9 P5 SPEED REGULATOR LEVER PIN GRIP BAND RUBBER GRIP GRIP SCREW THROTTLE LEVER RETAINING RING BALL BEARNING 1.