GENEVA DESIGN + ENGINEERING GROHE GERMANY 95.913.431/ÄM 224926/08.12 www.grohe.com 25 506 English D .....1 .....4 NL .....6 Français .....6 S .....7 GB .....2 .....8 Español F .....3 DK .....8 E I .....4 .....5 N .....9 FIN ...10 PL .....11 .....16 BG .....21 CN .....26 UAE .....12 TR .....17 EST .....22 UA .....27 GR .....13 SK .....18 LV .....23 RUS .....28 CZ .....14 SLO .....19 LT .....24 H P .....15 HR .....20 RO .....
Please pass these instructions on to the end user of the fitting! S.v.
II 2
1 *18 733 4 *18 734 J1 O1 J1 J G I J H I 30 mm M M1 N1 E 32 N D D1 COLD mm O B1 B2 B A mm 32 5 C2 19mm C HOT 24 mm C1 2 J R 29 3 6 L H H1 mm O J1 J1 J H I J G I I1 mm 41 I J 36 m A K m E 17mm A1 C2 24 45 883 mm COLD 45 882 HOT 3
English Application Operation is possible in conjunction with: - Pressurized storage heaters Operation is not possible with: - Low-pressure storage heaters (displacement water heaters) 3. Tighten with screw (J) and screw in cover cap (J1). It is recommended that the lever (G) be installed so they point away from the spout when in the off position. Spout, see fig. [3]. 1. Place the O-ring (I1) and the escutcheon (H1) on the tub deck. 2.
1 *18 733 4 *18 734 J1 J1 J G I J H I 30 mm O1 M M1 N1 E 32 N D D1 COLD mm O B1 B2 B A mm 32 5 C2 19mm C HOT 24 mm C1 2 J R 29 3 6 L H H1 mm O J1 J1 J H I J G I I1 mm 41 I J 36 m A K m E 17mm A1 C2 24 45 883 COLD mm 45 882 HOT 5
Français Domaine d'application Le service est possible en combinaison avec: - Des chauffe-eau à accumulateur sous pression 3. Serrez avec la vis (J) et vissez le capot (J1). On lui recommande que le levier (G) soit installé ainsi eux se dirigent loin du bec quand dans la position de repos. Bec, voir fig. [3]. 1. Poser le joint torique (I1) et la rosace (H1) sur le bord de baignoire. 2. Insérer le bec (H) dans la rosace (H1) et le bord de Caractéristiques techniques baignoire.
1 *18 733 4 *18 734 J1 J1 J G I J H I 30 mm O1 M M1 N1 E 32 N D D1 COLD mm O B1 B2 B A mm 32 5 C2 19mm C HOT 24 mm C1 2 J R 29 3 6 L H H1 mm O J1 J1 J H I J G I I1 mm 41 I J 36 m A K m E 17mm A1 C2 24 45 883 COLD mm 45 882 HOT 7
Español Campo de aplicación Es posible el funcionamiento en conjunción con: - Acumuladores de presión No instalar con: - Acumuladores de baja presión (calentadores de aqua sin presión) Datos técnicos • Caudal para una presión de trabajo de 45 psi: - caño aprox. 50 l/min o 13.2 gpm - ducha máx. 9.3 l/min o 2.5 gpm • Presión - mín. 7.25 psi - recomendada 14.5 - 72.5 psi - si la presión es superior a 72.5 psi, se deberá instalar una válvula reductora de presión • Presión de utilización máx.
D & +49 571 3989 333 impressum@grohe.de A & +43 1 68060 info-at@grohe.com AUS Argent Sydney & +(02) 8394 5800 Argent Melbourne & +(03) 9682 1231 B & +32 16 230660 info.be@grohe.com BG & +359 2 9719959 grohe-bulgaria@grohe.com CAU & +99 412 497 09 74 info-az@grohe.com CDN & +1 888 6447643 info@grohe.ca CH & +41 448777300 info@grohe.ch CN & +86 21 63758878 CY & +357 22 465200 EST & +372 6616354 grohe@grohe.ee F & +33 1 49972900 marketing-fr@grohe.