Instructions / Assembly

www.gronomics.com East Bethel, MN USA 763-753-7374

Continued

Western Red Cedar Cooler

(32” x 21” x 35”) Assembly Instruction

Parts Identiﬁ cation

Stack matching pieces in piles. Using the parts list, locate and count

the individual pieces and verify that you have received the correct

number of pieces.

If any pieces are missing or replacement parts are required,

contact Gronomics at 1-855-299-6727.

NOTE: It is recommended to place a protective layer between

the ground and the pieces during assembly. This will help prevent

damage to the pieces.

Item #: CC24-32

Packaged & Inspected by: Date:

Parts List

ITEM QTY. PART # DESCRIPTION

1 1 WRCCBA Western Red Cedar Cooler, 20” x 30”

2 4 3200CC Cooler Legs, 32”

3 1 CCBO Bottle Opener

4 24 CS8-112ZY Screws, GRK #8 x 1-1/2”

Torx® T15

NOTE: Place a protective layer on the ground for leg installation.

Remove the plastic cooler bottom from the cedar cooler.

Place the cedar cooler (Item 1) on its side on the ground (as shown).

Open the cedar cooler cover.

Pace two cooler legs (Item 2) under each side of the cooler (with the

straight cut end of the leg ﬂ ush at the top of the cedar cooler and the

beveled cut end of the leg down.

Cooler Leg Assembly

Remove The Plastic Cooler

Beveled End Of Leg

Open Cedar

Cooler Cover

Parts List

Product Care & Maintenance

Western Red Cedar will turn a weathered grey if

left unfinished. Although no finish is required for

cedar products when used outdoors,a natural oil

finish applied regularly will help maintain the

beauty and minimize cracking and drying. It is

recommended to use Gronomics Garden Bed

Oil (Item # GBO-1Q), a non-toxic, food safe

finish that is very easy to apply.

PAGE 1
Western Red Cedar Cooler (32” x 21” x 35”) Assembly Instruction 1 Item #: CC24-32 Parts Identification Stack matching pieces in piles. Using the parts list, locate and count the individual pieces and verify that you have received the correct number of pieces. 1 2 If any pieces are missing or replacement parts are required, contact Gronomics at 1-855-299-6727. NOTE: It is recommended to place a protective layer between the ground and the pieces during assembly.
PAGE 2
3 5 Cooler Leg Assembly (Continued) Cooler Leg Assembly (Continued) Make sure the cooler legs (Item 2) are flush with the top of the cedar cooler. Place the two remaining cooler legs (Item 2) onto the cedar cooler, make sure the cooler legs are flush with the top of the cedar cooler. Hold cooler legs tight too the cedar cooler sides and install six #8 x 1-1/2” screws (Item 4) through the cedar cooler walls and into the each cooler leg at the shown locations.