Instructions / Assembly

East Bethel, MN USA 763-753-7374
7
Post Cap Assembly
6
Bottom Board and Fabric Installation
Place one 31-7/8” x 5-1/2” corner notched bottom board (Item 3) on each
end of the garden bed.
Place six 31-7/8” x 5-1/2” bottom boards (Item 4) into the garden bed.
(Gap boards evenly to allow for water drainage).
Place fabric liner into the garden bed.
Soil Capacity: 8.9 Cubic Feet
Remove the rubber cap from the corner posts studs.
Align the hole of the 4” x 4” post cap (Item 2) with stud and tighten until
the cap makes contact with the post.
NOTE: Do not overtighten.
Repeat procedure on all posts.
3
End Rail Assembly
Install two 31” x 5-1/2” side rails (Item 5) (with grooves down) into the
slots and slide down to the bottom of the slots.
4
Narrow Center Side Rail Assembly
Install two 45” x 2-1/2” narrow center side rails (Item 7) into the slots and slide
down.
Install two 31” x 2-1/2” narrow center side rails (Item 6) into the slots and
slide down.
5
Final Side Rail Assembly
Rubber Cap
Stud
2
5
5
6
6
7
5
9
5
Logo
4
3
NOTE: Make sure the boards tongue and grooves fully seat together.
Install two 45" x 5-1/2" side rails (Item 9) (one w/logo) into the slots and slide
down. (Side rail with Logo located to outside)
Install two 31" x 5-1/2" side rails (Item 5) into the slots and slide down.
NOTE: Make sure the boards tongue and grooves fully seat together.