Instructions / Assembly
WWW.gronomics.com East Bethel, MN USA
763-753-7374
Continued
Remove the bench from the work table and place
the bench on the ground as shown.
Place the backrest spacers (Item 5) and backrest
surface panel board (Item 1) as shown. This will
allow a 1-3/8” gap between the backrest surface
panel boards.
NOTE: Make sure the backrest surface panel board
ends are flush with the ends of the seat surface
panel boards.
Install four 5/16” x 3-1/2” screws (Item 8) into the
pre-drilled holes and tighten.
Remove the backrest spacers.
Backrest Assembly
6
5
5
1
8
Place the backrest spacers (Item 5) at the top of
the lower backrest board. Place the upper
backrest board (Item 1) onto the spacers.
NOTE: Make sure the top backrest surface panel
board ends are flush with the bottom backrest
surface panel board ends.
Install four 5/16” x 3-1/2” screws (Item 7) into the
pre-drilled holes and tighten.
Remove the backrest spacers.
Backrest Assembly Continued
7
5
5
1
7