Instructions / Assembly

WWW.gronomics.com East Bethel, MN USA
763-753-7374
Continued
Place the leg support brace (Item 6) as shown and
install a 1/4” x 2-1/2” screw (Item 7) at each end.
Repeat procedure for leg support brace at opposite
end.
Leg Brace Assembly
6
6
7
Remove the bench from the work table and place
the bench on the ground as shown.
Place the backrest spacers (Item 5) and backrest
surface panel board (Item 1) as shown. This will
allow a 1-3/8” gap between the backrest surface
panel boards.
NOTE: Make sure the backrest surface panel board
ends are flush with the ends of the seat surface
panel boards.
Install four 5/16” x 3-1/2” screws (Item 8) into the
pre-drilled holes and tighten.
Remove the backrest spacers.
Backrest Assembly
7
5
5
1
8