Instructions / Assembly

WWW.gronomics.com East Bethel, MN USA 763-753-7374
Continued
Place three surface panel boards (Item 1) onto
a table or work bench.
Place the RH leg assembly (Item 3) as shown.
Repeat procedure at opposite end for the LH
leg assembly.
Seat / Leg Assembly
2
9”
9”
3
1
3
NOTE: Make sure the inner surface panel
board (Item 1) is tight against the leg
assemblies (Items 2 & 3) back rest supports.
NOTE: Screws will only be installed to the
inner surface panel board in this step.
Install two 1/4” x 2-1/2” screws (Item 6) into the
pre-drilled holes of the leg assemblies at each
end and tighten.
Seat / Leg Assembly Continued
3
Inner surface panel
board tight against
backrest supports.
6
1
3 2