Quick Reference Guide
Table Of Contents
- Contents
- Section 1: Introduction to Palm functions
- 1. PC system requirements
- 2. Understanding G18 interface and controls
- 3. Tapping versus clicking
- 4. Starting G18 and calibrating its screen
- 5. Adjusting screen brightness and contrast
- 6. To launch applications
- 7. Introduction to G18 interface
- 8. Setting up the G18 interface
- 9. Setting date, time and time zone
- 10.Setting Sleep Mode
- 11.Setting alert sound and volume
- 12.Setting system interface language
- 13.Setting up phone to phone IRDA data transfer
- 14.GPRS/communication setting
- 15.Using the onscreen keyboard
- 16.Installing add-on applications
- 17.Removing applications
- 18.HotSync Setting
- 19.IR HotSync operations
- 20.Flash BackupMan
- 21.Data transfer from other Palm terminals
- Section 2 : Communication and PDA Features
- Appendix I:Safety
- Appendix II: Install CD
- Appendix III: Specification
- Appendix IV: Care and maintenance
- Appendix V: Reset your G18
- Appendix VI: FCC Information
Section 1: Introduction to Palm functions
21.Data transfer from other Palm terminals
G18 Quick Reference Manual 30
Method 2(recommended):
If you want to use G18 and the phone at the same time, take following
steps:
1) Synchronize G18 with the Desktop,and create a new user. At the first
synchronization between G18 and the phone,a dialogue as is shown in
Figure 1 will open, tap the "New..." button, input the new username such as
"user2" in the pop-up dialogue. After the first synchronization,the Desktop
will create a user directory "user2" in the installed directory,and store
information used for synchronization in the user directory,as is shown in
Figure 2.
Figure 1