User's Manual
Table Of Contents
- Table of Contents
- About This Guide
- Safety
- Introduction to the G18 PDA PHONE
- System requirements for Windows
- G18 components
- Desktop Charger
- Tapping versus clicking
- Starting pda phone and calibrating screen
- Adjusting the brightness of your screen
- Adjusting the contrast of your screen
- To open applications
- Using the pda phone interface
- Palm Desktop software
- Connecting the HotSync cable
- Installing Palm Desktop
- Entering Data in Your G18 PDA PHONE
- Performing Common Tasks
- Managing Applications
- Working with Communication Applications
- Working with Studio Applications
- Working with Main Applications
- Enjoy with Game Applications
- Working with Utility Applications
- Working with System Applications
- Exchanging and Updating Data using HotSync® Operations
- Using the Attention Manager
- Using an Expansion Card
- Appendix : FCC Information
Exchanging and Updating Data using HotSync® Operations
IR HotSync operations
G18 User Manual 232
Configuring HotSync Manager for infrared
communication
Next you need to go to the HotSync Manager and specify the simulated
port used for infrared communication.
To configure HotSync Manager for infrared communication:
1. Click the HotSync Manager icon in the Windows system tray.
2. Make sure Local is checked on the menu.
3. Choose Setup.
4. Click the Local tab.
5. In the Serial Port drop-down box, select the COM port that was given
as the simulated port in the Options tab of the Infrared Monitor.
6. Click OK.
The HotSync Manager is now communicating with the simulated port
defined for infrared communication.
NOTE: You cannot use your HotSync cable again until you
reconfigure the HotSync Manager to communicate with the port defined
for HotSync cable synchronization.
Performing an IR HotSync operation
After you complete the steps to prepare for an IR HotSync operation it is
easy to perform the actual operation.
To perform an IR HotSync operation:
1. In the Applications Launcher, tap the HotSync icon.
2. Tap Local.
3. Tap the pick list below the HotSync icon and select IR to a PC/
Handheld.
4. Position the IR port of your organizer within a couple of inches of the
infrared port of your computer.
5. Tap the HotSync icon to start the IR HotSync operation.