User's Manual
Table Of Contents
- Table of Contents
- About This Guide
- Safety
- Introduction to the G18 PDA PHONE
- System requirements for Windows
- G18 components
- Desktop Charger
- Tapping versus clicking
- Starting pda phone and calibrating screen
- Adjusting the brightness of your screen
- Adjusting the contrast of your screen
- To open applications
- Using the pda phone interface
- Palm Desktop software
- Connecting the HotSync cable
- Installing Palm Desktop
- Entering Data in Your G18 PDA PHONE
- Performing Common Tasks
- Managing Applications
- Working with Communication Applications
- Working with Studio Applications
- Working with Main Applications
- Enjoy with Game Applications
- Working with Utility Applications
- Working with System Applications
- Exchanging and Updating Data using HotSync® Operations
- Using the Attention Manager
- Using an Expansion Card
- Appendix : FCC Information
Exchanging and Updating Data using HotSync® Operations
Conducting a HotSync operation via the modem
G18 User Manual 234
Preparing your computer
You must perform a few steps to prepare your computer for a modem
HotSync operation. Be sure to perform these steps before you leave your
office so that your computer is ready to receive a call from your pda phone.
To prepare your computer for a modem HotSync operation:
1. Confirm that the computer modem is connected and turned on, and
that no communications applications, such as fax or telephony
software, are running on a COM port.
NOTE: Make sure that the computer is disconnected from all online
services, such as America Online (AOL) and CompuServe, to avoid
conflicts with the COM port.
2. Start HotSync Manager if not running, and from the HotSync
Manager menu, choose Modem.
3. Adjust the following options as needed:
• Serial Port to identify the port for the modem. If you are unsure of
the port assignment, look at the Modem Properties in the Windows
Control Panel.