Installation and Operating Instructions

Page 1 Page 2 Page 3 Page 4 Page 5 Page 6
English (US)
Installation and operating
instructions
Table of contents
1.
Location 2
2.
Installing the product 3
3.
Control functions 4
4.
Approvals 4
5.
Fault nding 6
6.
Technical data 8
7.
Disposing of the
product 9
1. Location
This repeater is only for
use with the ALPHA 15-55
HWR-D system and is
intended for indoor
installation only in areas
safe from droplets and
splashes.
For optimum use, place
the repeater between the
ALPHA 15-55 HWR-D
pump and the push-button
located furthest away from
the pump.
2. Installing the product
To install the repeater:
1. Connect the included
USB cable to the repeater.
2. Connect the other end
of the USB cable to the
included power adapter.
3. Fit the included plug
adapter to the power
adapter.
4. Plug the power adapter
into a power outlet to power
on the repeater.
5. The LED on the repeater
will light green to indicate the
repeater is in operation.
3. Control functions
The repeater LED lights
green when the repeater is
in operation.
4. Approvals
FCC sections
Section 15.19 (a) 3
This device complies with
Part 15 of the FCC Rules.
Operation is subject to the
following two conditions: (1)
this device may not cause
harmful interference, and (2)
this device must accept
any interference received,
including interference
that may cause undesired
operation.
Section 15.21
Any changes or modica-
tions to this equipment
not expressly approved by
the party responsible for
compliance could void the
user’s authority to operate
this equipment.
Section 15.105 (b)
This equipment has been
tested and found to comply
with the limits for a class B
digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed
to provide reasonable
protection against harmful
interference in a residential
installation.
This equipment generates,
uses and can radiate radio
frequency energy and, if not
installed and used in accord-
ance with the instructions,
may cause harmful interfer-
ence to radio communica-
tions. However, there is no
guarantee that interference
will not occur in a particular
installation. If this equipment
does cause harmful interfer-
ence to radio or television
reception, which can be
determined by turning the
equipment o󰀨 and on, the
user is encouraged to try to
correct the interference by
one or more of the following
measures:
- Reorient or relocate the
receiving antenna.
- Increase the separation
between the equipment and
receiver.
be think innovate
99475028 0119
ECM: 1251564
- Connect the equipment to
an outlet on a circuit di󰀨er-
ent from that to which the
receiver is connected.
- Consult the dealer or an
experienced radio/TV techni-
cian for help.
This equipment should be
installed and operated keep-
ing the radiator at least 8 in
(20 cm) or more away from
person’s body.
Canadian ISED information
This equipment complies
with FCC/IC radiation
exposure limits set forth for
an uncontrolled environment
and meets the FCC radio
frequency (RF) Exposure
Guidelines and RSS-102 of
the IC radio frequency (RF)
Exposure rules.
Cet équipement est
conforme aux limites
99475028_0119_Repeater_HWR-D.indd 1-7 1/23/2019 3:25:49 PM