Install Instructions
Table Of Contents
- English (US)
- 1. Limited warranty
- 2. Symbols used in this document
- 3. General information
- 4. Mechanical installation
- 5. Electrical installation
- 5.1 Supply voltage
- 5.2 Connection to the power supply (models 40-XX, 50-XX, 65-XX, 80-XX, 100-XX)
- 5.3 Connection to the power supply (models 32-XX)
- 5.4 Connection diagram
- 5.5 Input/output communication
- 5.6 Analog input for external sensor
- 5.7 Electrical connection for external sensor
- 5.8 Priority of settings
- 6. First start-up
- 7. Settings
- 8. Menu overview
- 9. Control panel
- 10. Menu structure
- 11. "Home" menu
- 12. "Status" menu
- 13. "Settings" menu
- 14. "Assist" menu
- 15. Selection of control mode
- 16. Fault finding
- 17. Sensor
- 18. Accessories
- 19. Technical data
- 20. Disposal
English (US)
20
7. Settings
7.1 Overview of settings
All settings can be made on the pump control panel or with Grundfos GO Remote.
Menu Submenu Further information
Setpoint See section 13.1 Setpoint.
Operating mode See section 13.2 Operating mode.
• Normal
• Stop
• Min.
• Max.
Control mode See section 13.3 Control mode.
•AUTO
ADAPT
See section 13.3.1 AUTOADAPT.
•FLOW
ADAPT
See section 13.3.2 FLOWADAPT.
• Prop. press. See section 13.3.3 Proportional pressure.
• Const. press. See section 13.3.4 Constant pressure.
• Const. temp. See section 13.3.5 Constant temperature.
• Differential temperature See section 13.3.6 Differential temperature.
• Constant curve See section 13.3.7 Constant curve.
FLOW
LIMIT
See section 13.4 FLOWLIMIT.
• Set FLOWLIMIT
Automatic Night Setback See section 13.5 Automatic Night Setback.
• Not active
• Active
Relay outputs See section 13.6 Relay outputs.
• Relay output 1
• Relay output 2
Setpoint influence See section 13.7 Setpoint influence.
• External setpoint function See section 13.7.1 External setpoint function.
• Temperature influence See section 13.7.2 Temperature influence.
Bus communication See section 13.8 Bus communication.
• Pump number See section 13.8.1 Pump number.
General settings See section 13.9 General settings.
• Language See section 13.9.1 Language.
• Set date and time See section 13.9.2 Set date and time.
• Units See section 13.9.3 Units.
• Enable/disable settings See section 13.9.4 Enable/disable settings.
• Delete history See section 13.9.5 Delete history.
• Define Home display See section 13.9.6 Define Home display.
• Display brightness See section 13.9.7 Display brightness.
• Return to factory settings See section 13.9.8 Return to factory settings.
• Run start-up guide See section 13.9.9 Run start-up guide.