Install Instructions

3
English (US)
MANUFACTURER WILL NOT BE LIABLE FOR
ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES, LOSSES, OR EXPENSES ARISING
FROM INSTALLATION, USE, OR ANY OTHER
CAUSES. THERE ARE NO EXPRESS OR
IMPLIED WARRANTIES, INCLUDING
MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, WHICH EXTEND
BEYOND THOSE WARRANTIES DESCRIBED
OR REFERRED TO ABOVE. EXCEPT AS
EXPRESSLY HEREIN PROVIDED THE GOODS
ARE SOLD "AS IS", THE ENTIRE RISK AS TO
QUALITY AND FITNESS FOR A PARTICULAR
PURPOSE, AND PERFORMANCE OF THE
GOODS IS WITH THE BUYER, AND SHOULD
THE GOODS PROVE DEFECTIVE
FOLLOWING THEIR PURCHASE, THE BUYER
AND NOT THE MANUFACTURER,
DISTRIBUTOR, OR RETAILER ASSUMES THE
ENTIRE RISK OF ALL NECESSARY
SERVICING OR REPAIR.
Some jurisdictions do not allow the exclusion or
limitation of implied warranties of
merchantability and fitness for a particular
purpose, of incidental or consequential damages
and some jurisdictions do not allow limitations
on how long implied warranties may last or
require you to pay certain expenses as set forth
above. Therefore, the above limitations or
exclusions may not apply to you. This warranty
gives you specific legal rights and you may also
have other rights which vary from jurisdiction to
jurisdiction.
1.3 Symbols used in this document
2. Receiving the product
2.1 Inspecting the product
Examine the components carefully to make sure
no damage has occurred to the pump during
shipment.
3. Installing the product
3.1 Mechanical installation
3.1.1 Installing the base
Attach the base firmly to the wall surface with
four screws and anchors using the key holes
provided.
Fig. 1 Attach the base plate to the wall
with screws and anchors
WARNING
If you do not observe these safety
instructions, it may result in personal
injury.
WARNING
If you do not observe these
instructions, it may lead to electric
shock with consequent risk of serious
personal injury or death.
Caution
CAUTION
If you do not observe these safety
instructions, it may result in
malfunction or damage to the
equipment.
WARNING
Electrical shock and potential circuit
damage. Disconnect the power
supply before beginning installation.
All wiring must comply with national
and local electrical codes, ordinances
and regulations. Failure to follow
electrical codes could result in
serious personal injury, death, and
property damages.
Caution
CAUTION
Disconnect the power supply before
changing any DIP switch settings.
TM06 5607 5015
Base plate