Installation guide
ENGLISH
16
6 Select the line »DISEqC Mode« with »
C
«
or
»
D
«.
Select »DiSEqC 1.0« or »DiSEqC 1.1« in
accordance with the existing antenna system
with
»
B
« or »
A
«.
– DiSEqC 1.0 allows up to four satellites to
be received simultaneously.
– DiSEqC 1.1 allows up to 16 satellites to be
received simultaneously.
7 Select the line »LNB Selection« with
»
C
« or
»
D
«.
Select the setting for the respective satellites
with
»
B
« or »
A
«.
8 Once the settings for the satellite have been
made, switch to the »AUTOMATIC CHAN-
NEL SEARCH« menu with
»●« (red).
Select Satellite
Operator Selection
ASTRA 19.2°,E
Other
Service Type
All
Scan Mode
Free + Scramble
Network Search
Off
Connection Type
Satellite
Exit
Back
SOURCE SETUP
AUTOMATIC CHANNEL SEARCH
Start Search
08.08.2012
15:46
9 Select the line »Scan Mode« with »
C
«
or
»
D
«.
Select the scan mode with
»
B
« or »
A
«
(for unencrypted channels, for encrypted
channels only, or for both).
10 Select the line »Service Type« with
»
C
«
or
»
D
«.
Use
»
B
« or »
A
« to select whether you
want to search for television channels only
(TV), radio stations only (Radio) or both
(Radio + TV).
Note:
7
It is possible, that some TV channels (tran-
sponders) cannot be found. This is caused
by a change in satellite parameters made
by the broadcaster, e.g. new channels have
been added. Set the »Network Search« op-
tion to »On«.
11 Start the scan with
»●« (red).
– The »Results« menu appears, and the scan
for TV channels begins.
– Depending on the number of television
channels received, this can easily take a
few minutes.
– The scan is complete as soon as the »PRO-
GRAM TABLE« appears.
Note:
7
You can abort the scan by pressing »M«.
12 Press »M« to end the setting.
Note:
7
If other television channels are to be tuned
from a second satellite, proceed as follows:
Open the menu with »M«, select the line
»SOURCE SETUP« with
»
C
« or »
D
« and
press
»OK«
to confirm. Then select the
»Automatic Channel Search« with
»
C
« or
»
D
« and press
»OK«
to confirm. Confirm
the line »Select Satellite« with
»OK«
and
select the preferred satellite with
»
C
«, »
D
«,
»
B
« or »
A
«. Start the scan with »●« (red).
Continue the adjustment by step 7 of the
chapter.
SETTINGS
-----------------------------------------------------------------------------------------------------------------------------------------