User guide

73
ENGLISH
DIGI LINK
Your television is equipped with
DIGI LINK feature. This feature
utilizes CEC (Consumer Elec-
tronics Control) protocol. CEC
allows you to make an HDMI
connection between your TV and DVD player,
STB or video recorder and control such equip-
ments with the remote control of the television.
This feature must also be supported by the de-
vice you will connect.
You television supports the following functions.
For detailed information about this function, read
user manual of the external device.
Turning on external device from
standby mode
When you switch on your external device (e.g.
DVD player) from standby mode, your television
will be turned on from standby mode as well
and it will switch to the HDMI source that the ex-
ternal device is connected to.
Depending on the features of the external device
(e.g. AV receiver) can start and your television
can stay on stand-by mode.
Selecting the HDMI source from the
television
When you switch on your external device (e.g.
DVD player), your television will switch to the
HDMI source that the external device is con-
nected to. (your TV should be open).
Selecting the menu language
When you select menu language on your TV,
menu language of the external device will
change as well. (If your DVD player supports)
Switching off the device from
standby mode
After switching your television to standby, your
external device (e.g. DVD player) will also
switch to standby if it is switched on.
DIGI LINK is always active on your television.
Refer to the user manual of your external device
to learn how to activate this feature on it.
USING EXTERNAL DEVICES
---------------------------------------------------------------
Searching and selecting the active
external device
You can connect up to 11 devices that support
DIGILINK to this television.
1 Open the Tools menu with »TOOLS«.
2 Select the line »Digilink« with »
V « or
»
Λ «and press »OK« to confirm.
– Connected devices are searched and the
ones that are found are displayed on the
»Device List« menu.
3 Select the device that you want to control
with » V « or » Λ « and mark it with »OK«.
– If the selected device is connected to a
different source than the current one, you
will automatically switch to the source to
which the device is connected.