Operation Manual

87
ENGLISH
DISEqC Mode
Based on the number of current satellite sys-
tem, select the option »Off« »DiSEqC 1.0«
or »DiSEqC 1.1« with »
<
« or »
>
«.
– »Off«: For satellite systems with single
antenna.
– » DiSEqC 1.0« switch allows for receiving
from maximum four satellites at the same
time.
From »LNB Selection« use »
<
« or »
>
to make the »1/4«, »2/4«, »3/4« or
»4/4« selection for the satellite that
corresponds to relevant DiSEqC posi-
tions.
– » DiSEqC 1.1« switch allows for receiving
from maximum sixteen satellites at the
same time.
From »LNB selection« use »
<
« or
»
>
« to make the selections between
»1/16« and »16/16« for the satellite
that corresponds to relevant DiSEqC
positions.
8 Exit the antenna settings with »

« (blue).
9 Select the Channel Type.
Press »
V « or » Λ « to select whether you
want to search for only digital channels
(Digital) or only radio channels (Radio) or
both (Digital + Radio) and press »OK« to
select and mark or unmark the »Digital«
and/or »Radio« items.
10 Select Scan Mode.
To select whether you want to search for
only free digital television channels (Free),
only scrambled digital television channels
(Scrambled) or both (Free + Scrambled),
press »
V « or » Λ « and press OK« to select
and mark or unmark the »Free« and/or
»Scrambled« items.
11 Press »

« (red) to start searching.
Notes:
7
When updating via the same satellites a
security query is displayed at the start of a
search.
7
If the previously stored channels should
be retained in the channel list and the new
channels found be added to it, then press
»

« (green).
SETTING FURTHER CHANNELS
-----------------------------------------------------
7
If »

« (red) is pressed, the saved channels
will be deleted from the current channel list.
– The »Digital Searching« menu appears,
and the scan for TV channels begins.
– The search is complete as soon as the
message »Search is completed!« appears.
Note:
7
The search can be aborted with »EXIT«.
12 Switch to the Channel Editor with »

«
(yellow);
or
press »EXIT« to end the setting.
Note:
7
Repeat the procedure from point 1 for the
settings of the second satellite or any others.
These channels will be added to the bottom
of the channel table.