Operation Manual

Storing stations
You can programme 20 stations into the memory, 5 on each
waveband.
• Select the waveband with the BAND switch.
• Tune to the station you want to store.
• Press MEMO.
– The indication 'M' starts flashing on the
display for 5 seconds.
• Press the number (1…5) you want to
assign the station to.
• Press MEMO again to store the station.
• Select and store in this way all desired
stations.
Note:
If no station is stored within the 5 seconds that 'M' is flashing,
the storing mode is abandoned with no change to the current
memory.
Calling up a stored station
• Select the waveband with the BAND switch.
• To call up a stored station, simply press the corresponding
button.
– The unit switches to the station and the
display indicates the waveband, frequency,
'M' and the memory location number.
LW
M
kHz
SW M
MHz
SW M
MHz
OB 350 page 16
16
RADIO GENERAL
GB
SLEEP Function
• Press the SLEEP button briefly.
– The unit switches on the radio and the display
will show the previously set 'sleep' period.
• The 'sleep' time can be adjusted from 90
minutes --> 10 minutes by pressing the SLEEP
button continuously.
– After the preset sleep time has elapsed, the radio will switch
off automatically.
• The SLEEP function can be terminated prematurely by
pressing the
y button.
Key Lock
The Key Lock function is used to prevent accidental operation
or changes to the settings (e.g. when travelling, etc.).
• Set the Key Lock switch to the
t position.
– The '
t' indication lights up on the display.
• Now you can only adjust E VOL..,
BAND, DIST/LOCAL and RADIO/BUZZ.
• To disable this function, set the Key Lock switch back to the
tX position.
– The '
t' indication disappears from the display.
Use of the stand
• Fold out the stand on the rear of the set. You can now use
the set in an inclined position.
FM
MHz