Operation Manual

Radio reception
• Switch the radio on and off with the y button.
– The frequency and the wave band will
appear on the display.
• Select the desired waveband with the BAND
switch.
• Adjust the volume with the rotary control E VOL..
Aerials
• For FM reception extend the telescopic aerial fully. To
improve the reception you can incline and rotate the aerial.
If the FM signal received is too strong (in the direct vicinity
of the transmitter) you can retract the aerial.
• For MW and LW reception, the set has a built-in aerial, so
the telescopic aerial is not needed. You can direct the aerial
by turning the set itself.
• For short wave reception (SW) extend the telescopic aerial
and position it vertically.
Selecting Distant or Local
• Slide the
DIST/LOCAL selector to the LOCAL position to
reduce interference and distortion when listening to strong
FM or SW stations. This causes the signal to be weakened,
thus reducing interference.
FM
MHz
Automatic tuning
• To activate automatic station search (AUTO TUNING), press +
or – until the frequency display begins 'to run'; then release
the button.
– The search stops as soon as a station is
found and tuned to.
– Stations which are received with a weak
field strength may be skipped. These can be
tuned to manually.
Manual tuning
• Briefly press the + or – button to tune in the corresponding
direction in individual steps.
• If you keep the button depressed, you can rapidly scan
large frequency ranges.
– When you release the button,
AUTO TUNING is automatically
switched to.
• If you briefly press one of the + or – buttons, manual tuning
is switched to.
Last Station Memory
• Your unit is provided with the function 'LAST STATION MEMORY',
which means that the station that was playing when the set
was switched off will be selected again when the unit is
switched back on.
MW
kHz
OB 350 page 15
15
RADIO
GB