Operation Manual

83
ENGLISH
Displaying signal information
(for digital channels only)
1 Open the menu with »MENU«.
2 Select the menu item »SOURCE SETUP« with
»
V « or » Λ « and press »OK« to confirm.
3 Select the line »Signal Information« with
»
V « or » Λ « and press »OK« to confirm.
– Information on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
Notes:
7
The signal information changes in ac cord-
ance with the current input source.
7
The signal properties are displayed in the
lower section of the menu. The further the
bars for »Quality« and »Signal Strenght«
extend to the right, the better the reception
signal.
7
The signal level not only depends on your
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
4 Press »MENU« to close the menu.
SPECIAL SETTINGS
----------------------------------------------------------------------------------------------------------
Creating lists of favourites
You can select your favourite channels and save
them in up to four favourites lists (Fav 1 to Fav 4).
1 In the »PROGRAME TABLE« menu, switch
over to the list view with »

« (yellow).
2
Select the preferred channel with » V «
or » Λ « .
3 Use »
<
« or »
>
« to ”push“ the channel into
one of the favourites lists 1 to 4 and press
»OK« to confirm.
– The position in the favourites list is marked
with »✔«.
– You can enter the same channel in more
than one favourite list.
–
Each favourite list can store up to
250 channels.
Note:
7
Channels can also be deleted from favour-
ites lists. Select
the channel to be deleted
with »
V «, » Λ «, »
<
« or »
>
« and delete it with
»OK« . 
Exiting the settings
1 Press »MENU« to end the setting.