Operation Manual

2626
Changing frequency increments
1 Use »9 kHz 10 kHz« (in the battery compartment) to change the
frequency increments (FM 50/100 kHz, MW 9/10 kHz).
Note:
Switching the frequency increments deletes all stored settings (reset).
RDS station service
RDS (Radio Data System) is an information system which is transmitted
additionally by most FM stations. If the device is currently receiving an RDS
station, it displays the station name, e.g. »ENERGY«, and »f«.
Searching for RDS stations
1 Search for the desired RDS station by repeatedly pressing »TUNING
DOWN Ľ« or »TUNING UP Ń« briefly (incremental search) or
pressing and holding down (automatic search) until an RDS station is
received and »f« appears in the display.
– After a short time the station name appears if the reception strength is
sufficient.
Activating and deactivating RDS time synchronisation
When the device is on activated and an RDS station is received, the time
and day of the week are automatically updated. »w« appears in the
display.
1 To switch off RDS time synchronisation, briefly press »TIME« while the
device is on.
– Display: »w« disappears from the display.
2 To switch on RDS time synchronisation, briefly press »TIME« while the
device is on.
– Display: »w« flashes until the RDS time signal is received. Subse-
quently, »w«remains constant.
Calling up RDS information
When an RDS station is being received, the frequency is displayed briefly
and then the station name appears continuously.
1 Press »DISPLAY«.
– Display: the current time and day of the week.
2 Press »DISPLAY« again.
– Display: waveband, frequency and preset position.
– After a short time, the display changes back to the station name.
OPERATION
_______________________________________________
w f
ENERGY
w f
FM
100.60
w f
VILRADIO
w f
9
:
46 TU
w f
FM
106.90 9