Operation Manual

Antennas
1 For FM stations (VHF) extend the telescopic antenna »Antenne«.
Note:
If the FM signal is too strong, it is advisable to push in the telescopic antenna.
2 The radio has a built-in rod antenna for MW reception. Turn the device around to direct
the antenna.
Selecting the radio input source
1 Press »SOURCE« to select Tuner as the input source.
Setting and storing radio stations
Automatic station search
1 Press »
7
BAND« to select the frequency band (FM or MW).
2 Activate the station search by pressing »
8« or »9« until the frequency display changes
to rapid run-through.
– The search stops when a station is found.
Manual station search
1 To move the frequency up in steps, briefly press »8« or »9« several times.
– The frequency changes in 50 kHz steps (FM) and 9 kHz steps (MW).
Storing stations on station positions
Up to 10 stations in the FM band and up to 10 stations in the MW band can be stored.
1 Press »
7
BAND« to select the frequency band (FM or MW).
2 Press »
8« or »9« to select the station.
3 Press »PROG.« briefly to activate the memory function.
4 Press »P +« or »P –« on the remote control, or »A« or »
S
« on the device to select the
preset station.
5 Press »PROG.« to save the station.
6 To store more stations, repeat steps 2 to 5.
Note:
You can replace a station on a preset with a new one by carrying out steps 2 to 5 as
described above.
RADIO MODE _________________________________________________
ENGLISH
35