Operation Manual

ENGLISH
32
Notes:
7
Correct mounting is essential. Fixing materi-
als supplied are only intended for mounting
on walls made of solid wood, brick, concre-
te or on solid wood pillars, with a maximum
3 mm wall finish.
7
For walls made of other materials, e.g. hol-
low block, consult your installler and/or
specialist supplier.
7
Use other than for the prescribed equipment
falls outside the responsibility of the manu-
facturer.
1 Determine the installation place of the device.
Please note, the installation place should be
near a wall socket.
2 Pre-drill the four drill holes with 5 mm bit.
Note:
7
After drilling measure whether you have
drilled the right hole depth by sticking the
wall screws supplied into the drill hole. If the
screw fits right into the hole, the drill hole is
deep enough.
3 Insert the given plugs into the drill holes and
screw the wall part »D« of the wall bracket
firmly into the wall plugs using the four screws
supplied.
4 Release the four screws »A« in the bracket
(on the back of the device) and remove the
device’s stand.
5 Screw the device part »B« of the wall bracket
with the four supplied round head screws »C«
exactly (four threaded holes) to the back of the
device. All four screws must be used.
6 Insert the device with the openings of the de-
vice part »B« into the hooks of the wall part
»D« of the wall bracket and allow to latch in
place.
WALL MOUNTING
--------------------------------------------------------------------------------