Operation Manual
- 17 -
- 17 -
ENGLISH
5.6 Adjusting the digital receiver to the satellite antenna
This digital receiver was factory set so that it is ready for operation with most satellite an-
tennas and LNB configurations. Changes in this menu have a direct effect on the reception
characteristics of the digital receiver and should therefore only be made by an expert.
• Select “System Setup” in the main menu with ▼/▲ and
press OK to confirm.
• Select “LNB Settings” in the “System Setup” menu with
▼/▲
and press OK to confirm.
– The “LNB Settings” menu appears.
System Setup
Exit
Select
Back
OK
2 TV Setup
3 Language, Time
4 Hotel Mode
5 Information
6 Password Setting
7 Clear Channel List
MENU
Z
8 Factory Settings
1 LNB Settings
• Select “LNB System” in the “LNB Settings” menu with ▼/▲
and press OK to confirm.
– The following is displayed in the sub-menu:
“Off”:
For switching off the LNB power supply.
“Single”:
A single satellite is used for reception.
“Tone Burst”: Signals from two satellites can be re-
ceived.
“DiSEqC 1.0”: Signals can be received from up to 4
satellites.
LNB Settings
Exit
Select
Back
OK
LNB System
SAT System 1
Einzeln
Astra
MENU
Z
Off
DiSEqC 1.0
Single
Tone Burst
Exit
Select
Back
OK
MENU
Z
SAT System 1
LNB Type
Oscillator Low
Oscillator High
Astra
Low + High Band
09750 MHz
10600 MHz
Name
Receiving signals from a single satellite
• Select “LNB System” in the “LNB Settings” menu with
▼/▲
and press OK to confirm.
• Use
▼/▲ to select “Single” and press OK to confirm.
• Select “SAT System 1” with
▼/▲ and press OK to confirm.
• Use
▼/▲ to select the menu item to be changed and press
OK to confirm:
– “Name“ Change the satellite name.
• Use
◀/▶ to place the cursor under
the letter to be changed.
• Use
▼/▲ to set letters.
• Press OK to confirm.
– “LNB Type”
• Use ▼/▲ to select the LNB that is used.
• Press OK to confirm.
– “Oscillator Low” • Set the LNB oscillator frequency
(Low band).
• Use
◀/▶ to place the cursor un-
der the number to be changed.
—> Enter value with 1 … 0.
• Press OK to confirm.
– “Oscillator High“ • Set the LNB oscillator frequency
(High band).