Operation Manual

- 9 -
- 9 -
ENGLISH
Inserting batteries in the remote control
• Open the battery compartment and remove the lid.
• Insert the batteries (Mignon, e.g. UM-3 or AA, 2 x 1.5 V).
Observe the polarity marked in the battery compartment
base.
• Close the battery compartment.
Notes:
– If the digital receiver no longer reacts properly to remote
control commands or if the message “Low Battery!” ap-
pears, we recommend that the batteries are changed.
– Always remove used batteries.
The manufacturer accepts no liability for damage result-
ing from leaking batteries.
– The first time you use the digital receiver after changing
batteries, the message “Low Battery!” appears. Ignore
this message.
Environmental note
Do not throw away used batteries with your normal household waste. Instead take
them to a battery collection box in a shop or a public collection point.
Selecting remote control level SAT 1 or SAT 2
If you wish to use an RCR 100 remote control to operate two
DRS 100 CI digital
receiver , you must select a different remote
control level for one of the two digital
receiver .
TV Setup
Exit
Select
Back
OK
RGB
Auto
On
MENU
Z
TV
Picture Format
WSS
Teletext
IR Level
Cinch Audio
West
SAT 1
Fixed
SAT 1
SAT 2
• Connect the device and switch it on
(see chapters 4 and 5, pages 10 … 19).
• Press the MENU button to open the main menu.
• Use ▼/▲ in the main menu to select “System Setup” and
press OK to confirm.
• U se ▼/▲ to activate “TV Setup” and press OK to confirm.
• Select “IR Level” with ▼/▲ and press OK to confirm.
• Use ▼/▲ to select remote control level “SAT 1” or “SAT 2”
and press OK to confirm.
– If you wish to use the digital receiver with remote control
level “SAT 2” press and hold the button SAT button and
at the same time press the desired function button on the
remote control.
1
2
Î