Operation Manual

3. Hold the middle of the HDD bracket's handle with the index

finger and pull it forward while sustaining the bracket handle

with your thumb and middle finger as shown in the illustration

below.

4. Once the HDD bracket is separated from the main unit,

remove the 4 screws on both ends of the HDD bracket to

separate the HDD from the bracket.

5. Install a new HDD and fasten the 4 screws back to both ends

of the bracket to fix it.

NOTE: When installing the HDD, make sure to install it in the

correct direction.

6. Push the bracket installed with the new HDD back into the

main unit until it is completely inserted.

7. Assemble the front panel back to the unit.

ATTENTION: When assembling the front panel to the main

unit, make sure the marked part is tightly attached.

8. Fasten the 2 screws on both ends of the main unit.

English