Operation Manual

4.4.9. Network Connection

PC connection in the local network :

You can connect an NVR to a PC in the same network and control or edit it on the PC monitor.

1. Connect the [WAN(UPLINK)] port in the rear panel of the NVR to the router or hub.

2. Connect the local PC to the router or hub.

3. Enter the address in the address bar (web browser) of the local PC or of the dedicated software program in the

format of “http://IP address:web service port” (Ex : http://192.168.0.23:8080). The web service port is set to 8080

by default. From the Network Setup screen, you can change the port number.

4. Provide the ID and password when logging in. Then, you can view the monitoring screen.

Access ID (factory default) : ADMIN, P/W : 1234.

ATTENTION: For security purposes, change the password right after you purchased the product.

English