Operation Manual

DIRECT ACCESS:

In the direct configure tab you can activate the port forwarding of a dedicated camera. This will allow you to

access the camera webinterface through the IP address of the NVR.

Click on the <START> button to activate the direct configure mode. To access the camera enter the IP address +

the Webservice port of the NVR into your browser and enter the correct login data.

The IP address and the Webservice port you can find under SYSTEM > NETWORK > IP SETUP.

Click on the <STOP> button to leave the direct configure mode, after you have finished all settings.

NOTE: Functions of the camera that you cannot adjust with the NVR directly can be configured with the direct

configure mode. Functions that can be changed with the NVR should not be changed with the direct configure

mode, as the NVR will overwrite these after you have disabled the direct configure mode.

5. When done, press the [EXIT] button on the remote

control or click on <CLOSE> in the lower screen. The confirmation message appears and you will return to the

previous menu.

English