Operation Manual

6.2.4. Motion Sensor

Set the motion sensor of the camera so that the NVR can detect a motion event.

1. From <SYSTEM SETUP> - <CAMERA>, select <MOTION SENSOR>.

2. Use the [

▲▼

◀▶

/ENTER] buttons on the remote control or use the mouse to specify the use of each option item.

> ACTIVATION : Turn the motion sensor on or off.

> MOTION MARK : If you set it to <ON>, the video window will display the motion mark if a motion is detected.

3. To apply the change, click on <APPLY> in the bottom of the screen.

4. When done, press the [EXIT] button on the remote control or click on <CLOSE> in the lower screen. The

conﬁrmation message appears and you will return to the previous menu.

NOTE: The above options such as <SENSITIVITY> and <MINIMUM BLOCKS> and how to set the motion area may

be restricted depending on the speciﬁ cation of the connected camera.

Motion Area Setup :

In the motion setup window, click on <AREA SETUP> tab to display the motion area setup screen. Setting the

motion area may differ depending on the camera model. Below is a typical setting of the motion area.

English