Operation Manual

- DAYTIME : Specify the time period that will be considered as daytime.

- SENSITIVITY : Set the sensitivity level of the motion sensor to either Daytime or Nighttime: 1(Low) ~ 10(High) -

The higher the number is, the higher the sensitivity

level becomes.

- MINIMUM BLOCKS : Set the minimum number of blocks to Daytime or Nighttime if a motion is detected in

several blocks in the motion sensor area: 1(High) ~ 10(Low) - The lower the number is, the higher the sensitivity

level becomes.

- INTERVAL: Specify the time interval that will be used for motion detection. The lower the number the more

often motion detection will be triggered.

NOTE: The images recorded in a low contrast scene such as at night can cause severe noise, triggering the

motion event too often. If this is the case, please reduce the nighttime sensitivity to a degree.

6.2.5. PTZ Settings

You can set the camera ID, protocol, baud rate and data transmission speed for each channel.

1. From <SYSTEM SETUP> - <CAMERA>, select <PTZ SETUP>.

2. Use the [

▲▼◄►/ENTER] buttons of the remote control or mouse to set the address (ID), protocol and data

transmission speed for each channel.

3. To apply the change, click on <APPLY> in the bottom of the screen. Once clicked on the <APPLY> button after

changing the settings, a restarting message pops up. Click on <Yes> to restart the system automatically.

4. Once the setup is complete, press the [EXIT] button of the remote control or click on the <CLOSE> button on

the bottom to display a confirmation dialog. Click on <CANCEL> to return to the previous menu.

6.3. Display Setting

You can conﬁgure the display settings regarding the OSD menus, monitor and sequence.

6.3.1. OSD

Conﬁgure the settings for the time, title, border, icon and language that will be displayed on the screen.

English