Operation Manual

> IP ADDRESS : Provide the IP address.
> GATEWAY : Provide the gateway address.
> SUBNET MASK : Provide the subnet mask address.
> 1ST DNS SERVER : Enter the address of the primary DNS server.
> 2ND DNS SERVER : Enter the address of the secondary DNS server.
> RTSP SERVICE PORT : Port number that the remote client receives the NVR video from.
> WEB SERVER PORT : Port number used for connecting to the NVR with the web browser.
> PORT FORWARDING : If you are using a router, you can set the port forwarding so that the external access to th
e
NVR is enabled. If the router does not support the UPnP protocol, you must set the port forwarding manually.
For more information, contact your network administrator.
> DELETE PORT : Release the port forwarding settings for the router.
> MAX TX SPEED : Limit the network transfer rate to access a remote client. The video signal may be transferred
at a lesser rate than specified, which depends on the status of your network connection.
3. To apply the change, click on <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen. The
confirmation message will appear and you will return to the previous menu.
6.6.2. DDNS
You can configure the DDNS settings so that remote users who are connected to the network can access the
system remotely.
NOTE: DDNS is an IP redirection service in a dynamic IP environment that redirects (maps) the new IP address to
a registered domain name each time the IP address is changed.
1. From <SYSTEM SETUP> - <NETWORK>, select <DDNS>.
2. Use the [
▲▼◀▶/ENTER] buttons on the remote control or use the mouse to specify the use of DDNS and select
a server.
> DDNS : Specify the use of DDNS connection.
> DDNS SERVER : Select a server to connect to.
> NVR NAME : Enter the name of the NVR that you want to use as DDNS.
> DDNS REGISTRATION TEST : Check if the <NVR NAME> can be set as DDNS. If there is a duplicate name in the
server, the registration will fail. If this is the case, rename the <NVR NAME> and press <DDNS REGISTRATION
TEST> to check if it works properly.
> NVR ADDRESS : Provide the <NVR NAME> and press the <DDNS REGISTRATION TEST> button. The name
will be added automatically.
> DDNS CONNECTION TEST : Perform the connection test to check if DDNS is normally registered.
52
English