Operation Manual

3. To apply the change, click on <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen. The
confirmation message will appear and you will return to the previous menu.
6.6.3. Email
You can register and test an email address so that an email notification can be delivered at a specific interval or if
an event occurs.
1. From <SYSTEM SETUP> - <NETWORK>, select <EMAIL>.
2. Use the [
▲▼◀▶
/ENTER] buttons on the remote control or use the mouse to specify the use of email and select
a server.
> SERVER : Set up the mail server. Set the mail server that will be used for notification to the NVR. Use the virtual
keyboard to enter your mail server.
> PORT : Enter the mail server port.
> SECURITY : If it is set to <ON>, the email will be transferred in secure mode. If it is set to <OFF>, the email will
be transferred to a server that does not support SSL.
> USER : Provide the email account (ID) of the sender.
> PASSWORD : Provide the password of the sender.
> TEST EMAIL ADDRESS : Enter an email address for the test purpose.
> TEST : Send a test email and check if the test email is delivered normally.
3. To apply the change, click on <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen. The
confirmation message will appear and you will return to the previous menu.
6.6.4. Network Status
From the network map screen, you can check the internet connection status and IP camera connection status,
and check also the details of the connection status for each camera.
1. From <SYSTEM SETUP> - <NETWORK>, select <NETWORK STATUS>.
2. Use the [
▲▼◀▶
/ENTER] buttons on the remote control or use the mouse to select one from <NETWORK MAP>
and <DETAIL STATUS>.
3. When done, press the [EXIT] button on the remote control or click on <CLOSE> in the lower screen. The
confirmation message will appear and you will return to the previous menu.
53
English