Operation Manual

Network Map :

> IP ADDRESS : Indicates the internal IP address of the NVR.

> MAC ADDRESS : Indicates the internal MAC address of the NVR.

> DDNS ADDRESS : Indicates the internal DDNS address of the NVR.

> RTSP SERVICE PORT : Indicates the network port of the video service. For remote service, the router must have

set up the port forwarding.

> WEB SERVICE PORT : Indicates the web service network port. For the remote service to be enabled, the

corresponding port of the router should have set up the port forwarding.

> DDNS UPDATE STATUS : Shows if the DDNS address was registered to the DDNS server normally. Press the

'Blue Arrow in a Circle' Button next to the status to try to register the DDNS address forcibly.

> EXTERNAL IP ADDRESS : Indicate the IP address for the Internet, accessible from the NVR. The NVR can be

granted access with the web browser at "http://<External IP Address>:<Web Service Port>". The IP address can

vary in a dynamic IP environment.

> CONNECTED CLIENTS : Shows the list of clients that are currently connected. Press the according

'Connect/Disconnect' Button next to the chosen Client to terminate the connection of an unwanted client forcibly.

NOTE: Termination is limited to users in a lower group than the current user.

NOTE: The current PoE power consumption is updated sequentially in the order of channels.

NOTE: An Alarm is generated if the power consumption reaches 90% of the rated supply capacity, for both the

NVR main unit and the external PoE Hub. This alarm threshold setting can be edited in “EVENT > SYSTEM EVENT

> POE FAIL EVENT”.

English