Operation Manual

1. From <SYSTEM SETUP> - <STORAGE>, select <DISK INFORMATION>.

2. Use the [

▲▼◀▶/ENTER] buttons on the remote control or use the mouse to select either <INTERNAL DISKS>

or <EXTERNAL STORAGE>. Please check the status for each connected device.

> START / END TIME : Shows the start time and end time of data stored in each disk.

> STATUS : Checks if the connected disk is being used by the NVR. If you encounter a problem with the disk, the

NVR will terminate the connection to the disk and mark it as ‘Not In Use’.

> CAPACITY : Shows the capacity of the disk.

> MODEL : Indicates the disk model.

> S.M.A.R.T STATUS : Read the S.M.A.R.T information of the disk and check to display if the current disk is in

normal operation.

- NORMAL : The disk is in a normal state.

- CHECK : The disk has an error so that you need to check the disk or the connection cables of the disk. If you

leave the problem unresolved, no recording may be enabled. So it is recommended that you replace the disk

immediately.

- ERROR : The disk fails or is unable to be used due to an error of the disk or the cable. The disk should be

replaced immediately. Contact the retailer or the customer service to replace the disk.

English