Operation Manual

1. From <SYSTEM SETUP> - <STORAGE>, select <S.M.A.R.T. SETUP>.
2. Use the [
▲▼◀▶/ENTER] buttons on the remote control or use the mouse to check the S.M.A.R.T. operation and
specify the check interval.
> S.M.A.R.T. STATUS : Read the S.M.A.R.T. information of the disk and check to display if the current disk is in
normal operation. Click on <DETAIL INFO> to view the details.
- NORMAL : The disk is in a normal state.
- CHECK : The disk has an error so you need to check the disk or the connection cables of the disk. If you leave
the problem unresolved, the recording might be disabled. Therefore, it is recommended that you replace the disk
immediately.
- ERROR : The disk fails or is unable to be used due to an error of the disk or the cable. The disk should be
replaced immediately. Contact the retailer or the customer service to replace the disk.
> S.M.A.R.T CHECK INTERVAL : Specify the S.M.A.R.T check interval. Click on <CHECK NOW> to start checking.
3. To apply the change, click on <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click on <CLOSE> in the lower screen. The
confirmation message will appear and you will return to the previous menu.
6.9. Event Setup
Define various events, and specify the conditions for notifying the user in various ways.
6.9.1. Alarm Out
Specify the alarm output conditions with the work schedule.
64
English