Operation Manual

Alarm Out :

1. From <SYSTEM SETUP> - <EVENT>, select <ALARM OUT>.

2. Use the [▲▼

◀▶

/ENTER] buttons on the remote control or use the mouse to select <ALARM OUT> and conﬁgure

the related settings.

> NAME : You can rename the alarm.

> OPERATION : Set the alarm output mode.

- N/O (Normal Open) : It normally stays as Open. However, if an event occurs, it will switch to Close.

- N/C (Normal Close) : It normally stays as Close. However, if an event occurs, it will switch to Open.

> DURATION : Specify the duration of the alarm output.

- TRANSPARENT : Keep the alarm out for as much time as the event lasts.

- UNTIL KEY : Keep the alarm out until a mouse or remote control button is pressed.

- 5 ~ 300 SEC : Keep the alarm for as long as speciﬁed.

> TEST : Forcibly output the alarm for a test purpose.

3. To apply the change, click on <APPLY> in the bottom of the screen.

4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen. The

conﬁrmation message will appear and you will return to the previous menu.

ON/OFF Schedule :

You can activate or turn the alarm output off as scheduled.

English