Operation Manual

> NAME : You can specify the name of the alarm sensor.
> OPERATION : You can specify the type of the alarm sensor.
- N/O (Normal Open) : Normally the sensor is left as Open. If the sensor switches to Close, an event will be
triggered.
- N/C (Normal Close) : Normally the sensor is left as Close. If the sensor switches to Open, an event will be
triggered.
> LINKED CAMERA : Set the camera to synchronise with the alarm sensor when the sensor is triggered. If you
have set the alarm recording and the sensor detects the recording, all synchronised cameras will start the alarm
recording.
> PRESET : On alarm sensor’s detections, the camera moves as defined by the selected preset.
> ALARM OUTPUT : Specify the alarm output channel to be used in the case of a detection by the alarm sensor.
The alarm will be output to the specified channel.
> BUZZER : Specify the output of the buzzer if an alarm is detected by the alarm sensor.
> VIDEO POPUP : Select to display the video pop-up if an alarm is detected by the alarm sensor. If there exist
multiple <LINKED CAMERA>s, the video pop-up will be displayed in the maximum split mode.
> OSD POPUP : Select to display the OSD popup message to show in the case of a detection by the alarm sensor.
> EMAIL : Select to send an email if a detection by the alarm sensor occured.
3. To apply the change, click on <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click on <CLOSE> in the lower screen. The
confirmation message will appear and you will return to the previous menu.
6.9.4. Motion Sensor
You can set an action to execute when a motion is detected. For the settings of the motion sensor, move to
<CAMERA SETUP>.
1. From <SYSTEM SETUP> - <EVENT>, select <MOTION SENSOR>.
2. Use the [
▲▼◀▶
] buttons on the remote control or use the mouse to specify the ignorance interval and
operation.
70
English