Operation Manual

> IGNORING INTERVAL : Specify the minimum interval of the motion event occurrence. For example, even if you
have set the minimum frequency to 5 seconds and another motion event occurs in less than 5 seconds after the
last motion event occurred, the new event will be ignored. If too many motion events occur, adjust the setting to
shorten the interval.
NOTE : Motion recording will be triggered immediately after the motion occurred regardless of the above
settings.
> ALARM OUTPUT : Specify the alarm output channel if a motion is detected by the motion sensor.
> BUZZER : Specify the output of the buzzer if a motion is detected by the motion sensor.
> VIDEO POPUP : Select to display the video pop-up if a motion is detected by the motion sensor.
> EMAIL : Select to send an email if a motion is detected by the motion sensor.
3. To apply the change, click on <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click on <CLOSE> in the lower screen. The
confirmation message will appear and you will return to the previous menu.
6.9.5. Video Loss
You can specify a reaction to the case where no video is received from the camera.
1. From <SYSTEM SETUP> - <EVENT>, select <VIDEO LOSS>.
2. Use the [
▲▼◀▶
] buttons on the remote control or use the mouse to specify the reaction to a video loss.
> ALARM OUTPUT : Specify the alarm output channel if a video loss occurs.
> BUZZER : Specify the output of the buzzer if a video loss occurs.
> EMAIL : Select this to send an email out if a video loss occurs.
3. To apply the change, click on <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click on <CLOSE> in the lower screen. The
confirmation message will appear and you will return to the previous menu.
6.9.6. System Event
You can set any action to an event related to disk, recording, network or system. Like the other events, you may
notify the users of the event using the alarm/buzzer output, OSD pop-up or email.
71
English