Operation Manual

1. From <SYSTEM SETUP> - <EVENT>, select <SYSTEM EVENT>.

2. Use the [

▲▼◀▶] buttons on the remote control or use the mouse to specify the reaction to each event.

3. To apply the change, click on <APPLY> in the bottom of the screen.

4. When done, press the [EXIT] button on the remote control or click on <CLOSE> in the lower screen. The

confirmation message will appear and you will return to the previous menu.

Disk :

> START DISK OVERWRITE : If you set the disk write mode to <OVERWRITE>, this event occurs when the disk is

full and the overwriting begins accordingly.

> DISK FULL EVENT : If you set the disk write mode to <ONCE>, this event occurs when the disk is full (100%).

> DISK SPACE EXHAUSTED : Event that is triggered if the disk is almost full. Click to specify the threshold

percentage of usage to trigger the event.

> S.M.A.R.T. EVENT : Occurs if the disk causes the S.M.A.R.T. error.

> NO DISK : Occurs if no disk is recognised after booting due to a disk failure or cable problem.

NOTE: To detect a disk error, it is recommended not to change the settings of S.M.A.R.T. EVENT, NO DISK EVENT

and BUZZER OUT.

English