Operation Manual

33
EN
8. Troubleshooting
Drying process takes too much time.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm
water.
• Filter drawer is clogged. >>> Clean the sponge and the filter cloth in
the filter drawer.
• Ventilation grids on the front side of the machine are blocked. >>>
Remove the objects (if any) that block ventilation in front of the
ventilation grids.
• Ventilation may not be sufficient since the room where the machine is
installed is very small. >>> Open the door and windows of the room to
avoid the room temperature increase too much.
• Lime deposit has built up on the dampness sensor. >>> Clean the
dampness sensor.
• Excessive laundry might have been loaded in. >>> Do not overload the
dryer.
• Laundry might not be spun sufficiently. >>> Spin your laundry at a
higher speed in your washing machine.
Laundry comes out wet at the end of drying.
• A programme suitable for the laundry type might have not been
used.>>> Check the garment tag and select a programme suitable for
the fabric type or use the timer programmes additionally.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm
water.
• Filter drawer is clogged. >>> Clean the sponge and the filter cloth in
the filter drawer.
• Excessive laundry might have been loaded in. >>> Do not load the dryer
in excess.
• Laundry might not be spun sufficiently. >>> Spin your laundry at a
higher speed in your washing machine.
Dryer does not switch on or the programme does not start. Dryer does
not start when it is set.
• It might have not been plugged in. >>> Make sure that the machine is
plugged in.
• The loading door is ajar. >>> Make sure that the loading door is closed
securely.
• Programme is not selected or the Start / Pause button is not pressed.
>>> Make sure that the programme is selected and it is not in the
Pause position.
• "Child Lock" might have been activated. >>> Deactivate the Childproof
Lock.
Downloaded from www.Manualslib.com manuals search engine