Operation Manual

ManualsBrandsGrundig ManualsHouseholdGWN 37631

Loading door cannot be opened.

• Door lock is activated because of the water level in the machine. >>>

Drain the water by

running the Pump or Spin programme.

• Machine is heating up the water or it is at the spinning cycle. >>>

Wait until the

programme completes.

• Child lock is engaged. Door lock will be deactivated a couple of minutes after the

programme has come to an end. >>>

Wait for a couple of minutes for deactivation of the

door lock.

Washing takes longer than the specified in the manual.(*)

• Water pressure is low. >>>

Machine waits until taking in adequate amount of water

to prevent poor washing quality due to the decreased amount of water. Therefore, the

washing time extends.

• Voltage might be low. >>>

Washing time is prolonged to avoid poor washing results when

the supply voltage is low.

• Input temperature of water might be low. >>>

Required time to heat up the water extends

in cold seasons. Also, washing time can be lengthened to avoid poor washing results.

• Number of rinses and/or amount of rinse water might have increased. >>>

Machine

increases the amount of rinse water when good rinsing is needed and adds an extra

rinsing step if necessary.

• Excessive foam might have occurred and automatic foam absorption system might have

been activated due to too much detergent usage. >>>

Use recommended amount of

detergent.

Programme time does not countdown. (On models with display) (*)

• Timer may stop during water intake. >>>

Timer indicator will not countdown until the

machine takes in adequate amount of water. The machine will wait until there is sufficient

amount of water to avoid poor washing results due to lack of water. Timer indicator will

resume countdown after this.

• Timer may stop during heating step. >>>

Timer indicator will not countdown until the

machine reaches the selected temperature.

• Timer may stop during spinning step. >>>

Automatic unbalanced load detection system

might be activated due to the unbalanced distribution of the laundry in the drum.

Programme time does not countdown. (*)

• There might be an imbalance of laundry in the machine. >>>

Automatic unbalanced load

detection system might be activated due to the unbalanced distribution of the laundry in

the drum.

Machine does not switch to spinning step. (*)